Dynatech MP-5000 Instrukcja Obsługi Pobierz pdf (Strona 84)

80 Repair Procedures Welch Allyn Propaq Encore Vital Signs Monitor

Closing the Expansion Module

1. Make sure all cables are in place and the gaskets removed earlier are available.

2. Set the rubber gaskets in their proper places as shown in the figure below.

3. Connect the printer cable and expansion cable to the SCP or MSP board.

4. Set the chassis onto the rear panel, verifying that the gaskets don’t slip out of a

channel and become pinched between the rear panel and the chassis.

5. Torque screws to 4.75 in-lb to 5.25 in-lb (.54 N-m to .59 N-m).

Caution To prevent damage to the expansion module chassis, make sure that

the spacers are in place. The chassis may crack if screws are tightened without

the spacers in place. Note that the 5 upper spacers are not used when the SpO

module is present.

Gasket

Material

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 129 130

Brak uwag

Dynatech MP-5000 Instrukcja Obsługi Strona 84